Raven Viper Pro update NFG

[Guest]

My fence row nozzles are setup in the viper pro. However I deselect them when starting up that way you retain o ly manual control over them


1184h rogator

Mine are deselected also i think i will check It says when starting a job it will control the 7 sections and not femce row nozzles. Yours doesnt stop pump if you leave them on when your master is on but accuboom has booms all off ? Thats when this one stops pump

[furrowtickler]

120 ft ?

[Guest]

120 ft ?

No just a little one RG700, 90 ft

[furrowtickler]

Oohhhhh.

[Klause]

120 ft ?

Yes. 120

[Klause]

Mine are deselected also i think i will check It says when starting a job it will control the 7 sections and not femce row nozzles. Yours doesnt stop pump if you leave them on when your master is on but accuboom has booms all off ? Thats when this one stops pump

There's an option in the configuration for minimum pwm. I have it set so pump always runs for agitation. I'll check. I believe it's set to min 110

[Guest]

There's an option in the configuration for minimum pwm. I have it set so pump always runs for agitation. I'll check. I believe it's set to min 110

Im at 150. That gives me min 35psi with yellow tips but stil shuts off if it thinks it should be spraying out fence rows but cant cause accuboom has end sections off

[Klause]

Im at 150. That gives me min 35psi with yellow tips but stil shuts off if it thinks it should be spraying out fence rows but cant cause accuboom has end sections off

Are your fence row nozzles plumbed to the boom sections or a separate line to feed them?

[Guest]

Are your fence row nozzles plumbed to the boom sections or a separate line to feed them?

On the end of section 1 and 7 feeds off booms

[farmaholic]

That boom is split up into 7 sections? My 100 footer is only 5 but maybe the end row nozzles are each counted as a section.

Remember, I said I don't have them, it came with them on but I took them off and told the Viper Pro that they weren't there. We would have no use for them. Really, hardly any fences to spray against or trees either.

[Guest]

That boom is split up into 7 sections? My 100 footer is only 5 but maybe the end row nozzles are each counted as a section.

Remember, I said I don't have them, it came with them on but I took them off and told the Viper Pro that they weren't there. We would have no use for them. Really, hardly any fences to spray against or trees either.

No i ordered this with 7 sections plus fence row nozzles .less overlap. The bto's here are getting i think its called sharpshooter ? And that controls every nozzle . lotsa trees here it probably is just some setting but its smarter than i am . Maybe thats all
I gotta do is tell the son of a bitch that they arent there ? But they definetely arent included in the accuboom controlling

[Klause]

We have 7 sections plus two for the end rows. In viper I just deselect the fence row nozzles listed as * so I have *1234567*


That way you retain mechanical control and then they have their own fluid lines that T into the main supply line before it goes to sections 1 and 7