Theft of Canola in Alberta

[wmoebis]

Whenever I’ve seen it it’s in the probe sample. There’s usually enough of it to easily catch your eye. Assuming there’s a recommended amount per tonne.

It’s quite tiny so would probably be easy to miss if you just grabbed a handful to look. Doubt you’d be able to see it in the auger hopper from standing. Grading you see it because you’re looking close and it shows up in dockage. If a grader missed it I would be worried 😂😂 Even if they don’t know what it is.

Can also depend on the grain too. Cleaner canola it’s easy to see. Barley it can almost be invisible.

Good points! Often graders don't even look at the dockage they weight the clean (or some of) and don't even look at the DKG. That is the wrong way to do it however.

[Sheepwheat]

I remember a bit about getting samples with it in. One issue was with custom truckers the confetti could/would stick to wet or static stick to inside boxes and tarps. Then it would be comingle with next load. Ya not much but if even one piece raised concern to be used properly. Also grain vac could blow it out if used when loading.

If you are going to steal canola, getting rid of the confetti wouldn’t be all that hard. Could buy a cheap aspirator for 500 bucks, and run it through. I think the load value would cover that.

[farmboy44]

I remember a bit about getting samples with it in. One issue was with custom truckers the confetti could/would stick to wet or static stick to inside boxes and tarps. Then it would be comingle with next load. Ya not much but if even one piece raised concern to be used properly.

Under that scenario, if by chance one piece did stick up in the truck and then someone else’s grain went in it, the original producer would know that custom trucker and furthermore that truck in particular hauled grain for him likely just a couple days previous. In your example you even say it’s the next load.